Juniper ACX5048 Hardware Manual page 124

root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION:
interfaces within the same subnet, only one interface is usable and supported.
NOTE: The management ports, em0 (C0) and em1 (C1) are found on the FRU end of the
ACX5000 router.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
10. Enable telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a ACX5000 router through Telnet using
root credentials. Root login is allowed only for SSH access.
11. Commit the configuration to activate it on the router.
[edit]
root@# commit
RELATED DOCUMENTATION
ACX5048 and ACX5096 Installation Overview | 101
Although the CLI permits you to configure two management Ethernet
124