Juniper ACX5048 Hardware Manual page 141

1. Connect to the router using one of the following methods:
Connect a management device to the console (CON) port on an ACX5000 router. For instructions
about connecting a management device to the console (CON) port, see
Router to a Management Console" on page
You can shut down the ACX5000 router from a management device on your out-of-band management
network. For instructions about connecting a management device to the management (CO or C1)
port, see "Connecting an ACX5000 Router to a Network for Out-of-Band Management" on page
2. Shut down Junos OS from the external management device by issuing the request system halt
operational mode CLI command. This command shuts down the router gracefully and preserves system
state information. A message appears on the console, confirming that the operating system has halted.
You see the following output (or something similar, depending on the hardware being shut down) after
entering the command:
request system halt
warning: This command will halt all the members.
If planning to halt only one member use the member option
Halt the system ? [yes,no] (no) yes
Shutdown at Thu Jul 30 21:20:07 2015.
[pid 2434]
{master:0}
*** System shutdown message from root@acx5k11-ac ***
System going down in 1 minute
root@>
*** System shutdown message from root@acx5k11-ac ***
System going down in 30 seconds
*** FINAL System shutdown message from root@acx5k11-ac ***
System going down IMMEDIATELY
Terminated
.
120.
"Connecting an ACX5000
121.
141