Juniper ACX5048 Hardware Manual page 127

WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
WARNING:
or removing a cable. The rubber safety cap keeps the port clean and prevents
accidental exposure to laser light.
CAUTION:
Bending the cables beyond their minimum bend radius can damage the cables and
cause problems that are difficult to diagnose.
3. Remove the cable connected to the transceiver (see
ACX5000 Router" on page
with a rubber safety cap immediately after disconnecting the fiber-optic cables.
4. Using your fingers, pull the ejector lever away from the transceiver to unlock the transceiver.
CAUTION:
completely until you hear it click. This prevents damage to the transceiver.
5. Grasp the transceiver ejector lever and gently slide the transceiver approximately 0.5 in. (1.3 cm) straight
out of the port.
CAUTION:
not touch the connector pins at the end of the transceiver.
6. Using your fingers, grasp the body of the transceiver and pull it straight out of the port.
7. Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat, stable surface.
8. Place the dust cover over the empty port.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not leave a fiber-optic transceiver uncovered except when inserting
Do not bend fiber-optic cables beyond their minimum bend radius.
130). Cover the transceiver and the end of each fiber-optic cable connector
Before removing the transceiver, make sure you open the ejector lever
To avoid electrostatic discharge (ESD) damage to the transceiver, do
"Disconnecting a Fiber-Optic Cable from an
127