Table of Contents
Advertisement
•
•
•
•
Setting the IP, subnet mask, and gateway addresses (DSC 401 A only)
To set the IP address, subnet mask, or gateway address:
1.
2.
3.
4.
5.
Image Reset (DSC 401 A Only)
When an image reset is performed, the DSC attempts to size and position the image to fill
the display screen (fill mode) or use the native aspect ratio of the input (follow mode). Only
the horizontal and vertical image positioning and the horizontal and vertical image size are
adjusted by the image reset. All other controls are left unchanged.
•
•
Image reset is useful in applications in which a variety of new input sources may be
encountered (such as when a matrix switcher is connected). It is also useful for centering
and sizing an image that has been adjusted out of default settings.
You can perform a one-time image reset by the following methods:
•
•
•
•
IP Address — (DSC 401 A only) Sets the IP address for the unit. The default address is
192.168.254.254.
Subnet Mask — (DSC 401 A only) Sets the subnet mask for the unit. The default
subnet mask is 255.255.255.0.
Gateway — (DSC 401 A only) Sets the gateway address for the unit. The default
gateway address is 0.0.0.0.
USB Config IP — This view-only field displays the IP address (203.0.113.22) that is
automatically assigned to the DSC 401 and 401 A. This address is used for IP over USB
connections and can also be used for software such as PCS and Toolbelt.
Select the item to be changed from the Communications submenu and press Enter.
Press the
and
buttons to move the yellow selection arrows and highlighting to the octet to
t
Enter
be changed and press
button to select the desired value for the octet, then press Enter.
or
Press the
To rapidly increase or decrease the octet value, press and hold the
the desired value is displayed.
Repeat step 2 for the next octet to be changed, or press Enter again to return to the
submenu level.
If the aspect ratio has been set to Fill, the horizontal and vertical image position
returns to 0,0 and the horizontal and vertical image size is set to match the current
output resolution and rate.
If the aspect ratio has been set to Follow, the horizontal and vertical image position
and size are set to maintain the native aspect ratio of the input rate with respect to the
current output resolution.
Front panel button — While the OSD is not displayed, press the Image Reset ()
button twice. The first press displays the message Press Auto again to Confirm on
the OSD. The second press initiates the Auto-Image.
OSD submenu — Select Image Reset from the OSD Picture Controls submenu
(see
Image Reset
on page 19)
SIS commands (see the
Image Reset commands
PCS (see the DSC 401 and DSC 401 A Help File)
.
on page 49).
DSC 401 and DSC 401 A User Guide • Operation
or
button until
32
Advertisement
Table of Contents
