Preset Memory; Optimizing The Image - Extron electronics VSC 200 User Manual

im Vertrieb von

Preset Memory

Optimizing the Image

Menu button
www.camboard.de
CAMBOARD Electronics
The scan converter preset memory contains 130 locations that store scan rates and
associated size, zoom, pan, centering, and filter controls. The 30 user presets can be
changed or erased. The remaining locations are factory-loaded, permanent presets
that cannot be changed or erased.
When a video input is connected, the scan converter automatically scans the user
presets and then the factory presets, looking for a match to the input scan rate. If a
match is found, the stored settings become the active settings. If no match is found,
a user preset is created automatically using the default settings. If the user preset
memory is full, the new user preset overwrites the oldest user preset.
If a user preset is active and changes are made to the zoom, size, pan, or filter
controls, the changed settings are stored automatically in the preset memory for the
active scan rate. If a factory preset is used and changes are made to the zoom, size,
pan, or filter controls, a new user preset that includes the new settings is created.
To reset all user presets, perform a system reset (see page 3-4).
Preset memory does not include selections from the configuration controls
menu. The scan converter uses only the most recently applied configuration
controls selections.
Follow the procedures in this section, in sequence, after you have installed the scan
converter. This will help you configure the scan converter for the best settings for
your display environment.
1. Select the output standard:
a. Press and release the Menu button until the configuration controls menu
appears.
b. Press and release the Next button until the standard screen appears.
c. Press the Left or Right cursor button to select NTSC or PAL.
ZOOM/SIZE/PAN
Menu button
CONTROLS
OUTPUT RES. OUTPUT
Next button
xxxxxxxx
SVID <RGB> YUV
Figure 17 — Selecting the output standard
2. Size the image to fill the screen:
a. Press and release the Menu button.
b. Press and release the Next button.
c. Press the Left or Right cursor buttons until the image fills the width of
the screen. Press the Up or Down cursor buttons until the image fills the
height of the screen.
Turn the rotary knobs to keep the image centered while sizing it.
ZOOM/SIZE/PAN
Menu button
CONTROLS
Figure 18 — Sizing the image
Tel. 07131 911201
Fax 07131 911203
FILTER CONFIGURATION
Menu button
CONTROLS
CONTROLS
STANDARD
Next button
<NTSC> PAL
ZOOM
Next button
Next button
ce-info@camboard.de
VSC 200/200D/300/300D Operation
Next button
SIZE
V H
3-5