Table of Contents
Advertisement
Operation
This section discusses the functions available through the front panel and the on-screen
display (OSD) to configure and operate the DSC. Topics include:
•
•
•
•
•
•
•
•
•
•
•
Front Panel Features
A A A
A
B
C
Figure 8.
NOTE: Figure 8 shows the front panel of a DSC 401. The DSC 401 A front panel is
A
B
Front Panel Features
Powering On
On-screen Display (OSD) Menu
Image Reset (DSC 401 A Only)
Changing the Output Resolution and Refresh Rate
Power Save Mode
Switching Transitions
CEC Control (DSC 401 A Only)
Presets
Locking the Front Panel (Executive Mode)
Resetting
B B B
C C C
STATUS
SIGNAL IN
R
HDCP IN
CONFIG
HDCP OUT
Power and Reset LED
Reset button
USB Config port
DSC 401 Front Panel
identical except for the product name (DSC 401 A) in the lower-right corner.
— This bicolor LED lights amber when the unit is powered on
Power and Reset LED
but no signal is present, blinks amber every 3 seconds when the unit is in standby
mode, and lights steadily green when both power and an input video signal are present.
While the Reset button (see figure 8,
3 seconds to indicate the level of reset initiated if the button is released and momentarily
pressed again at that point (see
— Press this recessed button to access reset modes 1 (reset to factory
Reset button
firmware version), 4 (reset includes IP defaults), and 5 (absolute system reset, including
IP settings, user-defined settings, and user files) (see Resetting).
E E E
D D D
F F F
MENU
HOLD
FOR 1080p/4K
ENTER
Signal Status LEDs
D
Menu and Enter buttons
E
Navigation buttons
F
) is pressed and held, this LED blinks every
B
Resetting
on page 36 for more information).
DSC 401 and DSC 401 A User Guide • Operation
DSC 401
12
Advertisement
Table of Contents
