Table of Contents
Advertisement
Quick Setup Submenu
This submenu provides access to common DSC settings.
Figure 12.
From the Quick Setup submenu you can configure the following:
•
Input Format — This view-only field shows the connected input type (HDMI or DVI).
Input EDID — Press the
•
Input EDID on the
navigate through the selected list. Selecting Auto (the default) from the resolutions list
matches the current output resolution. There are also three custom options, prefaced
by C1:, C2:, and C3:.
•
Output Rate — Press the
and refresh rates (see Output Rate on the
There are three custom options, prefaced by C1: through C3:. The default setting is
1080p @ 60 Hz.
•
Audio Mute — Press the
Digital (mute embedded audio output), Analog (mute the analog output, DSC 401
A only), and Off (unmute audio, default) (see Audio Mute on the
page 27). Audio mute settings are retained after a power cycle.
•
Test Pattern — Press the
test patterns off (see Test Pattern on the
available test pattern selections are Crop, Alternating Pixels, Crosshatch, Color
Bars, Grayscale, and Audio Test (pink noise). The default setting is Off.
•
DHCP Mode — (DSC 401 A only) In DHCP mode, the unit is assigned an IP address
when it connects to the network (see DHCP Mode on the
starting on page 31). Press the
disabling (Off) DHCP mode. The default is Off.
Quick Setup Submenu
ƒ
and
„
buttons to select the resolution or the rate list (see
Input Submenu
>
<
and
>
and
<
buttons to select among On (mute all audio),
>
<
and
buttons to select a test pattern to display, or to turn
>
and
DSC 401 and DSC 401 A User Guide • Operation
>
on page 20). Press the
buttons to select from a list of output resolutions
Output Submenu
starting on page 23).
Advanced Submenu
Communications Submenu
<
buttons to toggle between enabling (On) and
and
<
buttons to
Audio Submenu
on
on page 29). The
17
Advertisement
Table of Contents
