Table of Contents
Advertisement
To connect indirectly to a device through a control processor via an AV LAN:
If your DSC 401 A is connected to an AV LAN, you can connect to it through a control
processor such as an Extron IPCP, as follows:
1.
2.
3.
4.
5.
See the DSC 401 and DSC 401 A Help File, included with PCS, for instructions on using
this software to configure the DSC.
Updating Firmware
Extron periodically updates product firmware. Before updating any Extron product to the
latest revision level, be sure to read the supplied release notes or contact Extron Technical
Support to determine if your product requires a firmware update.
You can update firmware using PCS (see the DSC 401 and DSC 401 A Help File) the
DSC 401 and DSC 401 A web page (see
the Toolbelt Help File).
In the IP Address/Hostname field of the
the previous page), enter the IP address of the DSC 401 A on the AV LAN, as well as
the port number and the password (if needed).
Select the Enable Indirect Connection checkbox (
In the IP Address/Hostname field of the IP Link Control Processor with AV LAN
panel (see figure 28,
on the previous page), enter the IP address of the control
4
processor connected to the AV LAN.
Enter the password if required.
Click Connect (
). The TCP/IP window closes and the DSC device configuration
5
window opens.
DSC 401 and DSC 401 A User Guide • Remote Configuration and Control
Device panel (see figure 28,
Target
).
3
Firmware Panel
on page 82), or Toolbelt (see
on
2
75
Advertisement
Table of Contents
