Initial Power Up Messages; Password Messages - Extron electronics DSC 401 User Manual

NOTE: Performing a unit factory reset (entering a ZQQQ

Initial Power Up Messages

The copyright message is displayed upon connecting to the unit via TCP/IP or Telnet.
] (c) Copyright YYYY, Extron Electronics, DSC 401, Vn.nn, 60-1878-01 ]
or
] (c) Copyright YYYY, Extron Electronics, DSC 401 A, Vn.nn, 60-1878-02 ]
Ddd, DD MMM YYYY HH:MM:SS ] (day, date, and time as in Wed, 07 Oct 2020 11:27:33)
YYYY is the year.
•
Vn.nn is the firmware version number.
•

Password Messages

If the DSC is protected by a password, the following password message prompts you for
the password to access the scaler features.
] Password ]
The prompt requires a password, followed by a carriage return. The prompt is repeated if
the correct password is not entered.
• For initial setup: Enter the serial number of your unit at the password prompt (the
serial number can be found on a label on the rear panel). This password allows
administrator level access.
If the correct password is entered, access is granted and the command prompt is
displayed. If the password is incorrect, the ] Password ] prompt reappears.
NOTE: Performing a unit factory reset (entering an E ZQQQ }
Reset
converts the serial number password to extron.
After a password change: After the initial access, you can keep the serial number
•
password or change it. You can also set administrator and user level passwords (see
Passwords commands
the
When you enter the new password correctly, the unit responds with one of the
following, depending on the password entered:
] Login Administrator ]
•
] Login User ]
•
(If the password is not accepted, the Password prompt reappears.)
The Login Administrator response represents administrator level access, while the
Login User response represents user level access. If the passwords are the same for both
administrator and user, the unit defaults to administrator privileges.
If the unit is not password-protected, it is ready to accept SIS commands immediately after
it sends the copyright message.
Reset] SIS command or a
changes the serial number password to extron.
SIS command or a mode 5 reset
starting on page 64).
DSC 401 and DSC 401 A User Guide • Remote Configuration and Control
[Absolute System
mode 5 reset via the front panel Reset button)
via the front panel Reset button)
[Absolute System
38