ICS Tunnel Master Jr. User Manual page 66

Symptom
Rollers keep coming up.
Equipment timing is off.
My receipts are not printing.
My reports are not printing
All of my equipment is shutting off
half way through the tunnel.
I am getting unloaded cars on my
shift reports.
Table 8-3. Miscellaneous Troubleshooting
Chapter 8: Troubleshooting
Cause
Check the pulse switch.
Check the pulse switch.
Printer is turned off.
Receipt Address is incorrect.
Printer is turned off.
Report Address is incorrect.
Faulty Gate Switch. Invalid/Max car
violation.
Min. Car Length set too high.
Cars not being loaded properly.
Anti-bounce is set incorrectly.
Remedy
Please refer to Wash Controller Input
Check.
Please refer to Wash Controller Input
Check.
Confirm printer is turned on and
error light is off.
Go in to wash settings and verify
that the receipt address is correct. If
the receipt printer is hooked up to
the keypad, it should be address 5.
If the receipt printer is hooked up
to the relay box, then the address
should be 0.
Confirm printer is turned on and
error light is off.
Go in to wash settings and verify
that the report address is correct. If
the report printer is hooked up to
the keypad, it should be address 5.
If the report printer is hooked up
to the relay box, then the address
should be 0.
Test your Gate switch. If you have
photo eyes, put something in front
of them and see if the gate light on
the relay box to see if it comes on.
If you have a loop, put something
metal over the loop and see if the
gate light on the relay box comes
on. If the gate does not function
properly, set Auto Gate to Y.
If your Min Car Length is set too
high, and a car that is less than the
min car length comes through the
eye, the system will not register it as
a car and the equipment will shut
off.
Roller is called up manually without
a service being loaded.
Your anti bounce should be higher
than your pulse length and less than
your min car length.
Tunnel Master® Jr. User Manual - Page 62