Bump A Shift Or Manually Close Current Shift - ICS Tunnel Master Jr. User Manual

It is very important that one of the two options be used each day. Failure to close a shift will result in car and
service counts being inaccurate, as they would run multiple days into one shift. You may also close your shift by
pressing the up arrow on the entrance keypad.
Reset - Pressing the up arrow key on the Entrance Keypad will reset your current car count!

Bump a Shift or Manually Close Current Shift

Step
1 Access the Main Menu by pressing the
"Menu" button on the display pad.
NOTE: If a password has been set it will be
necessary to enter the password before the
main menu can be accessed.
2 Press the numeric key 1 to select Bump Shift.
NOTE: A shift report will print automatically
at this point if there is an optional report
printer attached.
3 Using the numeric keypad press either Y for
yes, or N for no to close the shift at this time.
4 Press the ENT button on the display pad to
enter selection and return to the Main Menu.
Table 6-5. Bump a Shift or Manually Close the Current Shift
Chapter 6: Entrance Keypad
Action
[1] Bump Shift
[2] Wet Down Wash
[3] Configure Wash
Bump Shift
Bump Shift (Y/N)?
Bump Shift
Bump Shift (Y/N)? N
[1] Bump Shift
[2] Wet Down Wash
[3] Configure Wash
Screen Display
[4] View Counts
[5] Print Reports
[4] View Counts
[5] Print Reports
Tunnel Master® Jr. User Manual - Page 56