Advanced Menu - HP x4000 Technical Reference Manual

System BIOS and Resources
HP Setup Program

Advanced Menu

Table 4-2 describes the submenus available in the Setup program
Advanced menu.
Table 4-2
Field
Processors
Chipset
Floppy Disk
Drive
IDE Devices
52
This manual downloaded from http://www.manualowl.com
Advanced Menu
Description
Displays the type and the speed of the processor(s)
you have in your Workstation. You can change your
processor speed in the
selecting a value from the drop down menu. Your
processor cannot run any faster than what is
displayed in the
Current Type
Processor Speed set to the default of
processor speed is automatically detected. Use a
fixed frequency for troubleshooting only.
Memory Error Checking: You can choose between
and . ECC scrubbing checks for and
ECC Disabled
corrects errors at the source to prevent them from
reoccurring. Change this field to
to find errors, but don't want them corrected.
ECC Error Type: When an ECC error occurs, it
generates an interrupt. In this field, you can select
the type of interrupt you want reported:
(Non-Maskable), (System Management),
SMI
(System Control), or
None
SERR signal condition: In this field, you can select
the type of ECC error condition that triggers a
critical system error (SERR#). Normally, only
(unrecoverable) errors should be able to trigger
bit
SERR#. But you can also choose
.
Both
Contains the floppy disk drive type and controller
fields. If you choose to disable your floppy disk drive,
you must also disable your floppy disk controller.
Lets you configure the settings for the IDE controller
and any attached IDE devices.
field by
Processor Speed
field. If you leave
, the
Auto
if you want
Disabled
NMI
.
,
Single bit None
Chapter 4
,
SCI
Multiple
, or