Installing A Processor - HP x4000 Technical Reference Manual

Installing a Processor

To install a processor:
1. Turn off the display and shut down the Workstation. Disconnect all
2. Remove the Workstation's cover (see page 145).
3. Place the Workstation on its side for better access.
4. Open the hard disk drive cage (see page 149).
5. Remove the Chassis Beam Assembly (see page 152).
6. Remove the MEC card (see page 162).
7. Ensure the processor is correctly oriented by matching the notches on
CAUTION
Figure 10-22 Inserting a Processor
Step 7
8. Affix the new thermal interface material, provided with the new
9. Attach the heatsink to the processor. Use the retaining clips to attach
Chapter 10
This manual downloaded from http://www.manualowl.com
power cables and any LAN or telecommunications cables.
the processor to the notches on the ZIF socket. Then carefully lower
the new processor into place. When the processor is fully inserted,
close the ZIF lever.
Be extremely careful when you insert the processor. If you bend one of
the pins, it will not go into the socket.
processor, to the top of the processor.
the heatsink. For easier installation, partially attach both clips by
hooking one end of the side slot in each clip. Press down on the
remaining ends of both clips until they click into place.
Installing or Replacing Parts and Accessories
Processor
Step 9
177