HP x4000 Technical Reference Manual page 48

System BIOS and Resources
System BIOS
5. Set switch
on page 28.
6. Insert the floppy disk into the floppy disk drive.
7. Reconnect the power cord, and turn on the Workstation.
8. The workstation boots from the floppy disk, then flashes the BIOS.
During the flash process, the screen remains blank. When you hear
one long beep, the recovery process is finished.
9. Turn off the Workstation. Remove the floppy disk from the drive.
Remove the power cord and display cables, and remove the cover. (You
must press the pwoer buttong for 5 seconds to get the system to power
down.)
10. Set switch 2 back to
11. Replace the cover, reconnect the power cord, and reboot the
Workstation.
48
This manual downloaded from http://www.manualowl.com
on the system board to
2
.
OFF
. See "System Board Switches"
ON
Chapter 4