Hardware Management (Monitoring and Reporting)
Reporting
Reporting
Event Logging
Hardware monitoring errors, detected by the Hardware Management
Controller, are logged to the SEL (System Event Log). External agents,
such as the BIOS, can ask the Hardware Management Controller to log
errors on their behalf.
Sensor Report Using IPMI
Sensor information is available using the standard IPMI command,
Get
. The optional Sensor Device commands are not supported
Sensor Reading
by the HMC firmware. Dynamic setting of sensor thresholds is not
supported.
System Event Log (SEL)
Events are logged in the SEL using the standard SEL Event Record
format as defined in the IPMI spec, section 19.1. OEM SEL records are
also supported. The following SEL device commands are supported as
:
specified in section 18.1 of the IPMI spec
• Get SEL Info
• Get SEL Entry
• Add SEL Entry
• Clear SEL
• Get SEL Time
• Set SEL Time
• Reserve SEL
Power Status LED
The Power Status LED indicates the state of the system. See "HP x4000
Control Panel" on page 21. Error info has priority over power state info,
when the computer is on.
Chapter 5
77
This manual downloaded from http://www.manualowl.com