Starting E-Diag Tools From The Hp Workstation Recovery Cd-Rom - HP x4000 Technical Reference Manual

Troubleshooting
Using e-Diag Tools for Hardware Problems
Starting e-Diag Tools from the HP Workstation
Recovery CD-ROM
Use this method if for any reason you are unable to start this utility from
the hard disk drive partition. Before running e-Diag Tools from the
CD-ROM ensure:
• No operating system is specified:
• All Hardware Protection items in the Security menu are set to
• The option to start from the CD-ROM is enabled and the CD-ROM is
To start e-Diag Tools from the HP Workstation Recovery CD-ROM:
1. Insert the CD-ROM in the CD-ROM drive.
2. Restart the Workstation. The Workstation should boot from the
3. Select the option to run the hardware diagnostics and follow the
NOTE If you are unable to boot from your CD-ROM drive, restart your
Workstation and press
change the boot order from the Setup utility as described in "Boot Menu"
on page 57. Check the Boot device settings to ensure that your
Workstation can boot from the CD-ROM.
226
This manual downloaded from http://www.manualowl.com
— Start the Setup program as described in "HP Setup Program" on
page 49. If the Main or Advanced menu has an item Plug and
Play OS, set it to
No
— If the Main or Advanced menu has an item to select the operating
system, set it to
Other
or .
Enabled Unlocked
configured to be the first boot device.
CD-ROM rather than the hard drive.
directions on the screen.
F12
.
.
to change the system boot order. You can also
Chapter 11