HP x4000 Technical Reference Manual page 211

Clearing the Administrator Password
To clear the Administrator password:
1. Turn off the Workstation and remove the cover.
2. Set switch 1 on the system board switch block to
3. Replace the Workstation cover.
4. Turn on the Workstation and press
summary page.
5. When a message appears indicating that the passwords have been
cleared, turn off the Workstation and remove the cover. You must
press the power button for 5 seconds to turn off system.
6. Set switch 1 on the system board block back to
7. Replace the Workstation cover.
8. If you want to set new passwords, follow the instructions given in
"Setting Passwords" on page 224.
Chapter 11
This manual downloaded from http://www.manualowl.com
Troubleshooting
Solving Hardware Problems
.
ON
when prompted to see the
ESC
.
OFF
211