Table of Contents
Advertisement
DVG-5402G Wireless AC1200 Dual Band Gigabit Router with 3G/LTE Support,
2 FXS Ports and USB Port
User Manual
WPS
On the Wi-Fi / WPS page, you can enable the function for configuration of the WLAN and select a
method for connection to the WLAN.
The WPS function helps to configure the protected wireless network automatically. Devices
connecting to the wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
Before using the function you need to configure one of the following authentication types:
!
Open with no encryption, WPA2-PSK or WPA-PSK/WPA2-PSK mixed with the AES
encryption method. When other security settings are specified, controls of the WPS page
on the tab of the relevant band are not available.
You can activate the WPS function via the web-based interface or the hardware WPS button on the
cover of the device.
To activate the WPS function via the hardware button, move the Enable Wi-Fi when WPS
function is activated with hardware button switch to the right on the tabs of both bands.
Then, with the device turned on, press the WPS button and release. The WPS LED should start
blinking. In addition, upon pressing the button, the wireless interfaces of the device are enabled if
they were disabled before.
If you want to disable activating the WPS function via the hardware button, on the tabs of both
bands, move the Enable Wi-Fi when WPS function is activated with hardware button
switch to the left and make sure that the WPS function is not activated via the web-based interface.
Figure 102. The page for configuring the WPS function.
Page 123 of 244
Configuring via Web-based Interface
Advertisement
Table of Contents
