D-Link DVG-5402G User Manual page 183

DVG-5402G Wireless AC1200 Dual Band Gigabit Router with 3G/LTE Support,
2 FXS Ports and USB Port
User Manual
If you need to specify IP addresses of local and remote subnets for creating a tunnel, click the ADD
) in the Tunneled Networks section.
button (
Figure 149. The page for adding an IPsec tunnel. The window for adding a tunneled network.
In the opened window, you can specify the following parameters:
Parameter
Local network
Remote subnet
To edit fields in the Tunneled Networks section, select the relevant line in the table. In the
opened window, change the needed parameters and click the SAVE button.
To remove a subnet, select the checkbox located to the left of the relevant line in the table and click
the DELETE button (
After configuring all needed settings for the IPsec tunnel, click the APPLY button.
To edit the parameters of an existing tunnel, in the Tunnels section, select the relevant tunnel in the
table. On the opened page, change the needed parameters and click the APPLY button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
To disable VPN tunnels based on IPsec protocol, move the Enable switch to the left.
A local subnet IP address and mask.
A remote subnet IP address and mask.
). Also you can remove a subnet in the editing window.
). Also you can remove a tunnel on the editing page.
Page 183 of 244
Configuring via Web-based Interface
Description