Table of Contents
Advertisement
DVG-5402G Wireless AC1200 Dual Band Gigabit Router with 3G/LTE Support,
2 FXS Ports and USB Port
User Manual
CHAPTER 3.
Before You Begin
Please, read this manual prior to installing the device. Make sure that you have all the necessary
information and equipment.
Operating System
Configuration of the wireless dual band gigabit VoIP router
"the router") is performed via the built-in web-based interface. The web-based interface is available
from any operating system that supports a web browser.
Web Browser
The following web browsers are recommended:
•
Apple Safari 8 and later
•
Google Chrome 48 and later
•
Microsoft Internet Explorer 10 and later
•
Microsoft Edge 20.10240 and later
•
Mozilla Firefox 44 and later
•
Opera 35 and later.
For successful operation, JavaScript should be enabled on the web browser. Make sure that
JavaScript has not been disabled by other software (such as virus protection or web user security
packages) running on your computer.
Wired or Wireless NIC (Ethernet or Wi-Fi Adapter)
Any computer that uses the router should be equipped with an Ethernet or Wi-Fi adapter (NIC). If
your computer is not equipped with such a device, install an Ethernet or Wi-Fi adapter prior to using
the router.
Wireless Connection
Wireless workstations from your network should be equipped with a wireless 802.11a, b, g, n, or ac
NIC (Wi-Fi adapter). In addition, you should specify the values of SSID, channel number and
security settings defined in the web-based interface of the router for all these wireless workstations.
VoIP
On order to use VoIP over SIP, you need to connect an analog phone to an FXS port of the router.
Then access the web-based interface of the router, and you will be able to configure all needed
settings.
INSTALLATION AND CONNECTION
Page 20 of 244
Installation and Connection
DVG-5402G
(hereinafter referred to as
Advertisement
Table of Contents
