Table of Contents
Advertisement
DVG-5402G Wireless AC1200 Dual Band Gigabit Router with 3G/LTE Support,
2 FXS Ports and USB Port
User Manual
Basic Settings
On the USB Modem / Basic Settings page, you can view data on the USB modem connected to
the router and enable/disable the function for automatic creation of 3G/LTE WAN connection upon
plugging a USB modem into the router.
If the Automatic creation of connection switch is moved to the right and the PIN code check
for the SIM card inserted into your USB modem is disabled, then an active WAN connection with
default settings (for LTE modems) or the operator's settings (for GSM modems) will be
automatically created when plugging the USB modem into the router. The connection will be
displayed on the Connections Setup / WAN page.
If you don't want to use this function, move the Automatic creation of connection switch to
the left and click the APPLY button.
When a USB modem is connected to the router, the following data are displayed in the
Information section:
Parameter
Vendor
Model
Revision
IMSI
IMEI
Signal level
Figure 123. The USB Modem / Basic Settings page.
The manufacturer of your USB modem.
The alphanumeric code of the model of your USB modem.
The revision of the firmware of your USB modem.
The code stored in the SIM card inserted to your USB modem.
The code stored in the memory of the USB modem.
The signal level at the input of the modem's receiver. The zero
signal level shows that you are out of the coverage area of the
selected operator's network.
Page 151 of 244
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
