Usb Keyboard Support; Usb Mouse Support; Init Display First; Ac97 Audio - Kontron Mungo540 User Manual

USB Keyboard Support

Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.

USB Mouse Support

Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB mouse.

Init Display First

This field allows the system to initialize first the VGA board on chip or the
display on the PCI Slot. By default, the PCI Slot VGA is initialized first.

AC97 Audio

The options for this field are Enabled and Disabled. By default, this field
is set to Enabled.
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install an add-in FDC or
the system has no floppy drive, select Disabled in this field. This option
allows you to select the onboard FDD port.
Onboard Serial/Parallel Port
These fields allow you to select the onboard serial and parallel ports and
their addresses. The default values for these ports are:
Serial Port 1
Serial Port 2
Parallel Port

UART Mode Select

This field determines the UART mode in your computer. The settings are
Normal, IrDA and ASKIR. The default value is Normal.

RxD, TxD Active

The settings for this field are Hi,Lo, Lo,Hi, Lo,Lo, and Hi,Hi.

IR Transmission Delay

By default, this field is set to Enabled.
50
3F8/IRQ4
2F8/IRQ3
378H/IRQ7
Mungo540 User's Manual