Table of Contents
Advertisement
Blank Screen
Video Off In Suspend
This determines the manner in which the monitor is blanked. The settings
are: Yes and No.
Suspend Type
Select the Suspend Type. The settings are: PWRON Suspend, Stop
Grant
Modem Use IRQ
This field names the interrupt request (IRQ) line assigned to the modem (if
any) on your system. Activity of the selected IRQ always awakens the
system. By default, the IRQ is set to 3.
Suspend Mode
When enabled, and after the set time of system inactivity, all devices
except the CPU will be shut off.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
Soft-Off by PWR-BTTN
This field defines the power-off mode when using an ATX power supply.
The Instant-Off mode allows powering off immediately upon pressing the
power button. In the Delay 4 Sec mode, the system powers off when the
power button is pressed for more than four seconds or places the system
in a very low-power-usage state, with only enough circuitry receiving
power to detect power button activity or Resume by Ring activity (see
next field) when pressed for less than 4 seconds. The default value is
Instant-Off.
Wake-Up by PCI Board (PEM)
The settings for this field are Enabled and Disabled (default).
PWR On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
CPU Thermal-Throttling
The CPU Thermal Throttling function, by default, is set to 62.5%
RI7SM User's Manual
This option only writes blanks to the video buffer.
53
Advertisement
Chapters
Table of Contents
