Watchdog Timer Configuration
The function of the watchdog timer is to reset the system automatically
and is defined at WinbonW83627HF. To enable the watchdog timer and
allow the system to reset, the timer has a tolerance of 20% for its intervals.
The following example is writing in Intel 8086 assembly language and
describes how the timer should be programmed.
-------------------------------------------------------------------------------------
The setting Active allows you to select logic device 8.
-------------------------------------------------------------------------------------
MOV DX, 2EH
MOV AL, 87H
OUT DX, AL
OUT DX, AL
MOV DX, 2EH
MOV AL, 07H
OUT DX, AL
point to Logical Device Number Reg.
MOV DX, 2FH
MOV AL, 08H
OUT DX, AL
select logical device 8
MOV DX, 2EH
MOV AL, 30H
OUT DX, AL
select CR30
MOV DX, 2FH
MOV AL, 01H
OUT DX, AL
update CR30 with value 01H, Active GPIO2
RI7SM User's Manual
31