Table of Contents
Advertisement
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 168. Removing the intrusion switch module
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
NOTE:
Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly
when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align and slide the intrusion switch module into the slot in the system until firmly seated.
2. Using a Phillips #1 screwdriver, tighten the screw on the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the rear I/O board.
170
Installing and removing system components
Safety
instructions.
Before working inside your
riser.
system.
Advertisement
Table of Contents
