JDS Uniphase cORL-A1 Operating Manual page 27

Achieving compatibility with the
OLS-15
The Optical Power Source OLS-15 from JDSU (which is
no longer available) is equipped with special signal
modulation specifically matched to the Optical Power
Meter OLP-15 (also no longer available). You can
simulate this signal modulation to make the cORL-A1
compatible with the OLS-15.
1. Select Laser-Mode in the CONFIGURATION menu.
The SOURCE MODE menu opens:
2. Select the desired mode and press [MENU ENTER]
to accept the setting.
It is not possible to transmit several wavelengths
simultaneously (multi-λ operation) in OLS-15 mode.
Updating the firmware
The latest version of the firmware can be downloaded
from the internet at any time and stored in the EEPROM.
To find the latest firmware version:
1. Visit the JDSU web site at www.jdsu.com/
test_and_measurement.
2. Select your model from the product line.
3. Open the download area and download the latest
firmware.
You will also find step-by-step instructions on how to
update the firmware there.
After downloading the firmware to your PC follow the
steps below to install the firmware into your device.
JDSU
4 B
cORL-A1
O
ASIC PERATION
23