JDS Uniphase cORL-A1 Operating Manual page 24

4 B O
ASIC
Wavelengths cannot be reliably detected if:
• the receive level is too low,
• wavelength encoding cannot be detected due to
interference
• you are measuring the absolute level of a system that
does not have wavelength encoding that matches
JDSU power sources.
To switch Auto-λ mode on/off:
1. Select Select Auto-λ in the CONFIGURATION menu.
The AUTO-λ menu is displayed.
2. Select ENABLE to switch on Auto-λ
– or –
Select DISABLE to switch off Auto-λ.
3. Press [MENU ENTER] to confirm the setting.
λ
If Auto- mode is activated and a laser source
supporting Auto-
displayed in the bottom center display pane.
Display in Auto-λ mode
When Auto-λ mode is activated and different
wavelengths are detected, the power levels measured at
these wavelengths are displayed simultaneously.
Display in Auto-λ mode showing the detected wave-
Fig. 6
lengths and their power levels.
20
PERATION
λ
is connected
cORL-A1
, λ
Auto- will be
JDSU