JDS Uniphase cORL-A1 Operating Manual page 23

3. Press [MENU ENTER] again to edit the selected
wavelength (Edit is already selected).
The value to be edited is displayed:
4. Press [▲▼] to change the value:
- Press once to change one step at a time.
- Hold down the key to increase the step change rate.
5. Press [MENU ENTER] to set the new wavelength.
The EDIT λ-TABLE window is displayed again.
6. Press [MENU ENTER] again to change the view
status.
7. Select Show to show the wavelength in the table
– or –
Select Hide to hide the wavelength in the table.
8. Press [MENU ENTER] to confirm the selection.
Repeat steps 2 through 7 as required.
Enabling Auto-Lambda mode
Auto-λ is a special feature developed by JDSU that
allows you to identify wavelengths automatically. To do
this, the signal is modulated at a certain frequency (by a
light source equipped with Auto-λ, such as a JDSU
OLS-55/-56), which can be detected by a JDSU
cORL-A1.
JDSU
4 B
cORL-A1
O
ASIC PERATION
19