Door Preparation - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

BLSS Trim
ML2000 Series
Installation Instructions
3 Mortise Lock Handing Instructions (cont .)
4. Push in latch while holding screwdriver behind latch tail. (Figure 5)
Note:
Ensure that latch is pushed in until catch plate is no longer depressed. (Figure 4)
5. Rotate lock front to match bevel of door as shown. (Figure 6)
MAKE SURE CATCH PLATE IS EVEN
GOOD
4

Door Preparation

Important:
Be sure to hand the lockbody before installing.
1. Insert mortise lock into door and fully
tighten 1" lock mounting combination
screws. (Figure 7)
2. Turn-piece functions only:
Insert turn-piece door marker spindle
into lockbody on inside of door.
Note:
Use square side of door marker spindle. (Figure 8)
3. Turn-piece functions only:
Slide turn-piece door marker over spindle.
4. Turn-piece functions only:
Mark three holes for turn-piece. (Figure 9)
5. Coin-turn functions only:
Insert turn-piece marker spindle into lockbody
on outside of door.
Note:
Use square side of door marker spindle. (Figure 8)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
WITH TOP SURFACE
BAD
Figure 4
WARNING: LOCK-IN CAN
OCCUR IF LATCH IS NOT
PROPERLY INSTALLED
Figure 5
Figure 7
Turn-Piece Door
Marker Template
4
Figure 6
Blade Side
Figure 8
Inside of Door
Figure 9
FM351 08/19