Install Lock Front; Install Turn-Piece - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

BLSS Trim
ML2000 Series
Installation Instructions
6 Installation (cont .)
e

Install Lock Front

1. Install lock front using two (2) front
screws. (Figure 24)
f

Install Turn-Piece

1. Install turn-piece loosely using two turn-piece
mounting screws. (Figure 25)
Note:
Make sure lock is unlocked and turn-piece is
rotated towards latch.
2. Adjust location of turn-piece on door until
turn-piece rotates easily, then fully tighten
mounting screws. (Figure 26)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Unlocked
Figure 26
Locked
Figure 24
Figure 25
9
FM351 08/19