Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual page 5

BLSS Trim
ML2000 Series
Installation Instructions
4 Door Preparation (cont .)
6. Coin-turn functions only:
Slide turn-piece door marker template over spindle.
7. Coin-turn functions only:
Mark two holes for coin-turn. (Figure 10)
8. Remove lockbody from door.
9. Turn-piece functions only:
Drill one middle hole (.290") and two outer holes (3/8")
halfway through door. (Figure 11)
10. Coin-turn functions only:
Drill two holes (1/8") halfway through door. (Figure 12)
11. Turn-piece functions only:
Install turn-piece thru-bolt plate using truss head screw.
Leave screw slightly loose. (Figure 13)
Note:
The thru-bolt plate is installed inside the door pocket.
12. Insert mortise lockbody into door and loosely tighten
1" lock mounting combination screws.
Note:
Make sure lock is unlocked. (Figure 14)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Ø1/8"
Thru-bolt Plate
Figure 12
Turn-Piece Door
Marker Template
Outside of Door
Ø3/8"
Ø.290"
Figure 13
5
Figure 10
Ø3/8"
Figure 11
Unlocked
Locked
Figure 14
FM351 08/19