Configuring The Fpga - Xilinx Virtex UltraScale FPGA VCU1287 Getting Started Manual

Select an option
7. Select option 2 (Free-Run crystal) operating mode when prompted.
Choose si5368 operating mode:
1 - Auto-Select
2 - Free-Run using XA-XB crystal

Configuring the FPGA

The VCU1287 board additionally utilizes the Xilinx XC7Z010CLG225 Zynq-7000 AP SoC
System Controller to implement a System Integrated Configuration Engine (System ICE) to
configure the FPGA using one of the configuration *.bit files provided on the SD card in
8-bit SMAP configuration mode.
The FPGA can also be configured through the Vivado Design Suite using the *.bit files
available on the SD card and online (as collection rdf0368-vcu1287-ibert-2016-4.zip)
at the Virtex UltraScale FPGA VCU1287 Characterization Kit documentation
Review UltraScale Architecture Configuration User Guide (UG570)
information about UltraScale device configuration.
1. Insert the SD card provided with the VCU1287 board into the SD card reader slot located
on the bottom-side (upper-right corner) of the VCU1287 board.
2. From the main System Controller menu, select option (7) to access the UltraScale FPGA
configuration options:
VCU1287 System Controller v1.0
- Main Menu -
-----------------------------
1. Set Programmable Clocks
2. Get Power System (PMBUS) Voltages
3. Get Power Monitoring Data (INA226)
4. Adjust FPGA Mezzanine Card (FMC) Settings
5. Get GPIO Data
6. Get EEPROM Data
7. Configure UltraScale FPGA
VCU1287 IBERT Getting Started Guide
UG1203 (v2016.4) December 15. 2016
Chapter 1: VCU1287 IBERT Getting Started Guide
www.xilinx.com
website.
[Ref 4] for additional
Send Feedback
16