Xilinx Virtex UltraScale FPGA VCU1287 Getting Started Manual page 14

3. Connect J1 connector (USB/UART) on the VCU1287 board to the host computer using
one of the standard-A plug to micro-B plug USB cables provided
power up the board by placing SW1 in the ON position.
X-Ref Target - Figure 1-11
4. Open a serial communication terminal application on the host computer, for example
"HyperTerminal", and connect to the port number associated with the enhanced COM
port of the Silicon Lab USB-UART Bridge. Set up a new connection as in
press the Return key to connect to view the System Controller options menu.
X-Ref Target - Figure 1-12
VCU1287 IBERT Getting Started Guide
UG1203 (v2016.4) December 15. 2016
Chapter 1: VCU1287 IBERT Getting Started Guide
Figure 1-11: USB-UART Connector
Figure 1-12: Terminal Setting
www.xilinx.com
(Figure
X15550-121416
Figure
X15551-121416
Send Feedback
1-11) and
1-12, and
14