Polycom RealPresence Centro User Manual page 42

Procedure
1. In a video call, tap
2. Tap Auto Camera Tracking Off.
Turn On Far End Camera Control
You might want to enable Far End Camera Control (FECC), so that the far site can pan, tilt, or zoom the
local camera. When this feature is enabled, a participant at the far site can control the framing and angle
of the camera for the best view of the near site.
Procedure
1. From the Home screen, tap
2. Scroll to Camera.
3. Touch and drag the Far Control of Near Camera slider to the right.
Turn Off Far End Camera Control
You can disable Far End Camera Control (FECC) to stop far-end participants from controlling the framing
and angle of the local camera.
Procedure
1. From the Home screen, tap
2. Scroll to Camera.
3. Touch and drag the Far Control of Near Camera slider to Off.
Camera Presets in Single Camera Mode
In Single Camera mode, camera presets are stored camera positions that you can create before or during
a call. Presets enable you to quickly point a camera at pre-defined locations in a room and select a video
source, such as a document camera or an auxiliary camera. Presets remain in effect until you change
them.
The system uses preset 0 as the default camera position for all preset camera positions. This default
camera position is zoomed out, panned straight ahead with horizontal tilt.
If your system camera supports pan, tilt, and zoom movement, you can create up to 10 preset camera
positions for the near-end camera. Each preset stores the following information:
• Camera number
• Camera zoom level
• Direction the camera points
If far-end camera control is allowed, you can create 10 presets for the far-end camera as well. These
presets are saved only for the duration of the call. You can also use presets that were created at the far
end to control the far-end camera, if enabled by the administrator.
Keep the following camera control information in mind when using Self View:
• When in a call, selecting near camera control pans and zooms the local camera without changing
the layout.
• When out of a call, selecting camera control changes the Self View to full screen.
• Incoming calls override the full-screen Self View layout.
.
Settings then User Settings.
Settings then User Settings.
Using RealPresence Centro with Skype for Business
40