Polycom RealPresence Centro User Manual page 12

Table
System State Call State
Off
On Video call
On Video call
On Video call
On Audio call
On Not in a call
On Not in a call
System Health Check
After being powered on, the system automatically performs a system health check. This process is known
as a Power On Self Test (POST). The status of the POST sequence is shown with the status indicators at
the base of the solution. All test results are logged in the memory.
If a severe error occurs during startup, the RealPresence Centro does not power on. Contact your
Polycom Reseller or Polycom technical support if this happens.
Wake the RealPresence Centro System
After a period of time set by your administrator, the RealPresence Centro goes into Power Saving mode
and the monitors go to sleep. When the system is in Power Saving mode, you can wake it at any time.
Procedure
» Tap one of the touchscreen monitors, press any button on the remote control, or pick up the
remote control.
Using the Remote Control
The remote control enables you to operate the RealPresence Centro in addition to controlling the system
with the touch monitors or a touch device. You can control all aspects of the solution with the remote
control, including placing calls, adjusting the volume, and navigating menus. You can control the
RealPresence Centro by pointing the remote control toward the monitors.
Recharge the Remote Control Battery
When the remote control battery power is low, a notification displays on the system Home screen. You
can use the USB ports on the base of the system to charge the battery. Recharging the battery can take
from 20 minutes up to multiple hours, depending on the battery level.
Getting Started with Polycom
Additional Controls
Camera On
Hide Self View
Camera Off
Show Self View
Hide Self View/Camera Off
® ™
RealPresence Centro
Camera Position
Down
Up
Up
Up
Up
Up
Down
10