Secure the sensor mounting bracket to the machine using two M10 x 1.5 x 25 mm hex bolts (P/N 311-0070-
21.
008), two 0.406" ID x 0.812" OD x 0.065" thick washers (P/N 313-2300-014), and two M10 x 1.5 nylon insert
lock nuts (P/N 312-4000-208).
Note:
Do not fully tighten.
Sensor Shaft Installed in WAS Coupler
FIGURE 25.
Insert the sensor shaft into the installed WAS coupler.
22.
Tighten the installed nuts and bolts.
23.
Installation is complete. Proceed to Chapter 5, Cab Component Installation.
24.
Manual No. 016-5034-004
Wheel Angle Sensor Installation
37