Raven SmarTrax Installation Manual page 36

Chapter 4
Sensor Centering Bracket Installed
FIGURE 14.
Slide the sensor centering bracket tight against the kingpin bolt as shown in Figure 14 above.
4.
Note:
The bracket should be positioned so that the slot is in line with the front axle.
Fully tighten the kingpin bolt, ensuring the bracket stays aligned with the axle and tight against the kingpin
5.
bolt.
WAS Coupler Installed
FIGURE 15.
Flat Face of 'D'
Profile
Install the WAS coupler (P/N 307-0159-419) in the rectangular cutout of the sensor centering bracket.
6.
Note:
The flat side of the 'D' profile should be closest to the machine's engine.
Rotary Sensor Installed on Sensor Bracket
FIGURE 16.
Sensor
Connector
Bracket
Base
32 John Deere 7X00/7X10 Series SmarTrax™ Installation Manual