Table of Contents
Advertisement
8.2.2 Adjust temperature
If in temperature calibration the admitted divergence is exceed or not reached, the
temperature of the instrument can be adjusted as described below.
1.
Select menu item <7 – Heater Calibration> (see chap. 8.2.1, step 1) and
confirm by
2.
Confirm the inquiries <Are you sure> and the following instruction how to use
a temperature calibration set by
The current settings of the both temperature points T-lo / T-hi are displayed.
3.
Press
select between <T-lo> and <T-hi>. Acknowledge with
4.
Press
, the first heating phase is started.
5.
Temperature calibration for the first point takes 15 min. Compare the
temperature displayed on the DLB-A01N with that of the moisture analyzer.
If the two values do not match, correct with
6.
Confirm by
TDLG_A-BA-e-2011
.
to select the desired test temperature and press
, the second heating phase is started.
.
.
.
to
23
Advertisement
Table of Contents
