Installing The Slotted Disc (Speed Measuring System) - HBM T10FM Mounting Instructions

22
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com

4.8 Installing the slotted disc (speed measuring system)

In order to prevent the slotted disc of the speed measuring system being da-
maged during transportation, it is not fitted to the rotor. The customer must at-
tach it to the intermediate flange before mounting the rotor in the shaft run.
The intermediate flange and the associated rotation speed sensor have al-
ready been fitted at the factory.
The requisite screws, a suitable screwdriver and the screw locking device are
included in the list of components supplied.
Fig. 4.8: Mounting the slotted disc
CAUTION
When carrying out installation work, be careful not to damage the slot-
ted disc!
Assembly sequence
1. Push the slotted disc onto the additional flange and align the screw holes.
2. Apply some of the screw locking device to the screw thread and tighten
the screws (tightening torque < 15 N⋅cm).
HBM
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
Flange B
Slotted disc
Screw for mounting
the slotted disc
turned in the cutting
plane
Intermediate flange
T10FM
B 23.T10FM.10 en