Setting The Pulse Count; Vibration Suppression (Hysteresis) - HBM T10FM Mounting Instructions

T10FM
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com

7.4 Setting the pulse count

In the case of the speed module option, the number of pulses per revolution of
the rotor can be adjusted by using DIP switches S1...S4.
Fig. 7.6: Switches for setting the pulse count
Setting the pulse count
1. Remove the stator cover.
2. Use switches S1...S4 in accordance with Table 7.1 to set the required
pulse count.
Pulses/revolution
Table 7.1: Switch position for the pulse count (
1)
Factory settings

7.5 Vibration suppression (hysteresis)

Low rotation speeds and higher relative vibrations between the rotor and the
stator can cause disturbance signals that reverse the direction of rotation.
Electronic suppression (hysteresis) to eliminate these disturbances is connec-
ted at the factory. Disturbances caused by radial stator vibration amplitudes of
approx. 2 mm are thus suppressed.
B 23.T10FM.10 en
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
Switch S1...S4
1)
720 360
S4
S1
180 90 60
¢ switch lever)
33
30 15
HBM