Mounting The Clamping Part - HBM T10FM Mounting Instructions

20
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com
7. Fasten the stator-housing screwed joints.
8. Make sure that the opening in the lower antenna-segment
section is free from electroconductive foreign substances.
CAUTION
To make sure that they function perfectly, the fan-type lock washers
(A5,1–FST DIN 6798 ZN/galvanized) must be replaced after the screwed
joint of the antenna has been detached three times.

4.7 Mounting the clamping part

Depending on the operating conditions, the antenna ring may be excited to vi-
brate. This effect is dependent on
• the speed,
• the antenna diameter (depends in turn on the measuring range),
• the construction of the machine foundations.
To avoid vibrations, a clamping part with an extension is enclosed with the tor-
que flange enabling the antenna ring to be supported.
Fig. 4.6: Supporting the antenna ring
HBM
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
Support supplied by customer
Clamping part
Extension
Antenna ring
T10FM
Opening
B 23.T10FM.10 en