Victoria Arduino BLACK EAGLE VA388 Service Manual page 14

1.5 TRANSPORT
The machine is transported on pallets which also
contain other machines - all boxed and secured
to the pallet with supports.
Before carrying out any transport or handling
operation, the operator must:
as well as a set of overalls which must be
elasticated at the wrists and ankles.
The pallet must be transported using a suit-
able means for lifting (e.g., forklift).
1.5.1 HANDLING
WARNING
COLLISION OR CRUSHING HAZARD
During the entire handling operation, the opera-
tor must make sure no one or nothing is inside
the operating area.
Slowly lift the pallet to about 30 cm from the
ground and move to the loading area. After
making sure there are no obstacles, persons or
things, proceed with loading.
Once at destination, always using an adequate
lifting mechanism (e.g. fork-lift), after making
sure there is no one or nothing within the unload-
ing area, lower the pallet to about 30 cm from the
ground and transport it to the storage area.
WARNING
COLLISION OR CRUSHING HAZARD
Before performing the following operation, make
sure the load is in place and is not likely to fall
when the straps are cut.
The operator, wearing safety gloves and foot-
wear, must now cut the straps and store the
product. To perform this operation, check the
technical characteristics of the product to deter-
mine the weight of the machine to be stored and
take consequent precautions.
1.8
SERVICE MANUAL
Fig. 13
Once the machine has been removed from
the pallet or the container, do not dump them
- pollution hazard.
WARNING
RISK OF POLLUTION
Edition 01 of 08/2017