Changing Confirmation Ids - Siemens SIPROTEC 5 Manual

[scsprums-040613-01.tif, 1, en_US]
Figure 8-53
•
The setting is accepted in the device through Load configuration in devices.
•
When prompted, enter the confirmation ID and finally click Ok.
The operation panel language changes automatically after it is downloaded from the PC to the device.

Changing Confirmation IDs

8.8.7
Authorization for security-relevant operations on the device directly via the on-site operation panel or DIGSI 5
is assured by the assignment of confirmation IDs. These confirmation IDs are assigned exclusively using
DIGSI 5. You can find more information in the Security Manual.
Changing Confirmation IDs on the PC in DIGSI 5
To reach the menu for the confirmation IDs of your SIPROTEC 5 device, use the project-tree window.
Project → Device → Security
The confirmation IDs for 4 different access types will appear in the main window.
•
Activate or deactivate a confirmation ID by setting or removing a check mark in the Active column.
•
To change a confirmation ID, click the change button in the Action column. The change window opens.
•
Enter the new confirmation ID (comprising 6 digits from 0 to 9) twice, and then confirm it with OK. The
confirmation IDs are set ex factory as default (see table
[sc_security_password_confirmationID, 2, en_US]
Figure 8-54
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020
Language Change with DIGSI 5
Window for Activating Confirmation IDs
Operation in the Operating State
8.8 Change Device Settings
Table 8-13).
195