Siemens SIPROTEC 5 Manual page 156

Operation in the Operating State
8.4 Indications
Acknowledgment via the operating menu
•
Log on to the device.
•
In order to reach the reset functions from the main menu, use the navigation buttons of the on-site
operation panel.
•
Select on the device display:
Main menu → Device functions → Reset functions
You will be offered different Reset functions.
Figure 8-11
Detailed overview of the Reset functions:
Res. Binary Outputs
•
Log on to the device.
•
Use Res. binary outputs to reset stored output contacts.
•
Actuate the softkey Start in the base bar.
The device display will then briefly display the indication Cmd. exec. Succeded.
Res. LED not in Grp.
•
Log on to the device.
•
Use Res. LED not in Grp. to reset stored LEDs that are not assigned to a special function group.
•
Actuate the softkey Start in the base bar.
The device display will then briefly display the indication Order successfully saved.
Depending on the device configuration, other protection function groups are displayed to you as submenus
for which separately corresponding, stored LEDs can be reset. Proceed with the other function groups as
shown in the following example.
Line 1 (example)
•
Go to the submenu of the selected function group (example Line 1).
•
Use Reset LEDs to reset stored LEDs in the selected function group.
•
Actuate the softkey Start in the base bar.
The device display will then briefly display the indication Order successfully saved.
Figure 8-12
Acknowledgment of Stored Indications via Binary Inputs
Acknowledgment by binary input >LED-Reset switches on all LEDs (LED Test). After signal dropout, all stored
indications, stored LEDs, output contacts, and spontaneous fault displays are reset.
156
Reset Functions on the On-Site Operation Panel (Example)
Reset Functions on the On-Site Operation Panel (for Example, Line FG)
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020