Taking Out Of Operation And Disposal; Repair Or Changing Of Location; Product Disposal - Siemens ULTRAMAT 6 Series Compact Operating Instructions

Taking out of operation and disposal

8.1

Repair or changing of location

If the analyzer is shut down for repair or for changing the location of use, proceed as follows:
When the device is used in hazardous areas
A hot work permit is required for hazardous areas.
1. Make sure that gas is no longer flowing through the analyzer. If external pumps are present,
switch all of them off.
2. Purge the sample gas path with air or nitrogen.
3. Switch the analyzer off.
4. Disconnect the power plug.
5. Disconnect all hose connections from the rear of the analyzer.
With pipe versions, unscrew all pipes.
8.2

Product disposal

Danger of chemical burns for ULTRAMAT 23
The O2 sensor contains acetic acid, which leads to burns on unprotected skin. Therefore, do not
use any tools when replacing the sensor module which could damage the sensor
through sharp edges or squeezing.
If contact with the acid occurs nevertheless, rinse the affected skin immediately with plenty of
water!
Series 6 and ULTRAMAT 23
Compact Operating Instructions, 01/2024, A5E45779144002-AB
DANGER
The analyzer to be disposed of as electronic waste with the code number
160213 is a 'product containing dangerous components'. It must therefore be
disposed of correctly and in an environmentally-friendly manner by a local
waste disposal company.
It must never be disposed of with household waste!
WARNING
8
63