Siemens SIPROTEC 5 Manual page 84

Using On-Site Operation Panel
5.3 Displays for Indication and Control
[scabzstb-100211-01.tif, 1, en_US]
Figure 5-5
A ready-to-run device with large graphic display shows you the control display defined as the standard after
booting. By pressing and holding down the left navigation key, you get to the control display defined as
standard. By pressing the control key, you get to the control mode of the currently displayed control display.
NOTE
i
i
The switching device in control mode is selected by pressing the following navigation keys:
•
Top
•
Bottom
You can leave control mode via the softkey Exit. If no keys are pressed for 15 minutes, the default display is
automatically activated and control mode is reset.
If there are multiple displays, you can use the left and right navigation buttons to toggle between the displays.
If the device was previously in control mode by pressing the CTRL key, this mode is maintained so that you can
also activate a 2nd and another control display. Control mode is reset after a switching procedure or after a
period of 15 minutes without a switching operation.
For this see the description of the navigation keys in
84
Control Display
Table 5-1.
C53000-G5040-C003-C, Edition 08.2020
SIPROTEC 5, Operation, Manual