Installing Pmc - Motorola IXP-9120 Reference Manual

Switch Settings
Table 7: Switch settings (cont.)
Switch
SW3
Note: Positions 3 and 4 of SW3 are used together as indicated in Table 6.
Table 8:
Position 3
OFF
ON
OFF
ON

Installing PMC

To install a PMC, follow these steps:
1. Switch off power.
2. Remove IXP/CPCI-9120 from the system according to the removal procedure
steps (see "Installation in a Non-Powered System" page -54).
3. Locate the PMC slot on IXP/CPCI-9120 into which you are installing the PMC.
4. Remove the PMC slot filler from front panel of IXP/CPCI-9120.
50
Position Description
1
OFF: Front Panel Reset enable
ON: Front Panel Reset disable
2 OFF: PrPMC Monarch disable
ON: PrPMC Monarch enable
3 OFF: Auto-detect (BMC or PM mode)
ON: Force BMC mode
4 OFF: Depends on Switch position 3
ON: Force PM
IPMI Mode Selection
Position 4
OFF
OFF
ON
ON
Installation
Mode selected
Auto Detect
Force BMC
Force PM
Force PM
IXP/CPCI-9120