Configuring The Platform; Executing Diagnostics; Board Diagnostics Commands - Motorola IXP-9120 Reference Manual

Introduction

Configuring the Platform

Executing Diagnostics

Diagnostics are executed under the control of a diagnostic command line interface as shown
below
CPCI920_DIAG>
Run any of the diagnostics tests that are listed in the subsequent sections.

Board Diagnostics Commands

Note: All memory addresses are entered in hexadecimal format without the 0x prefix.
When specified without
the command was issued.
Listed below are the different Board Diagnostics commands for IXP/CPCI-9120:
t/test
t/test
D
ESCRIPTION
Displays a list of test commands within the diagnostics image.
S
YNTAX
test <interface/module>
P
ARAMETERS
interface/module
Example:
The following command invokes the xscale scratchpad tests.
t xscale s p
help/h?
D
ESCRIPTION
Prints the help screen for a given diagnostic command.
S
YNTAX
h <command>
P
ARAMETERS
is the command for which help information has to be displayed
command
146
and , it displays the contents of the last address when
addr size
is the interface or module that has to be tested.
Diagnostics
IXP/CPCI-9120