Replacing The Service Processor Interface Card In The 9080-M9S System - IBM 9080-M9S Manual

Hide thumbs Also See for 9080-M9S:

Table of Contents

Figure 504. Removing a service processor interface card from the system

Replacing the service processor interface card in the 9080-M9S system

To replace the service processor interface card in the system, complete the steps in this procedure.

1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged

into a ground jack or connected to an unpainted metal surface. If not, do so now.

2. To replace a service processor interface card, complete the following steps:

a) Ensure that the service processor interface card handle (A) is open as shown in the following figure.

b) Hold on to the service processor interface card handle and by using your hand to support the

bottom of the service processor interface card, push the service processor interface card into its

slot as shown in the following figure.

c) Rotate the handle to the left in the direction shown in the following figure to lock the service

processor interface card into the system.

580 Power Systems: Removing and replacing parts in the 9080-M9S system

Show Quick Links

Table of Contents