Service And Operating Positions; Placing An 5104-22C, 9006-22C, Or 9006-22P System Into The Service Position - IBM 9006-22C Installing And Configuring

Figure 67. Replacing and securing the cover
3. Replace the two cover screws, one on each side of the cover.
Service and operating positions for 5104-22C, 9006-22C, or 9006-22P
Learn how to place an system into the service or operating position.

Placing an 5104-22C, 9006-22C, or 9006-22P system into the service position

To place a system into the service position, complete the steps in this procedure.
Before you begin
Notes:
• When you place the system in the service position, ensure that the cables at the rear of the system do
not catch or bind as you pull the system unit out of the rack.
• When you place the system into the service position, ensure that all stability plates are firmly installed
to prevent the rack from toppling. Ensure that only one system unit is in the service position at a time.
• When the rails are fully extended, the rail safety latches lock into place. This action prevents the system
from being pulled out too far.
Common procedures for servicing or installing features in the 5104-22C, 9006-22C, or 9006-22P system 117